Need help with coding after rear fog install

I installed the depo led taillights with rear fog yesterday. I followed the directions on Vortex and put in the yellow trigger wire and swap the gray with white stripe wire with blue and green stripe wire.

I have the euro switch and a existing yellow trigger wire for parking lights/

My car has the xenon headlights with led drls.

originally byte 18 was set to 20 with this only my driver side led was lit up along with rear fog after install

change to 15 everything works except both right/left led drl

I tried 22,1F,43, 00, 03,04 and whatever else I could find after searching the last 3 hours for answers.

Any ideas on what else it could be or I could try? Did I screw up something in the wiring?

I did drive it around after installing the taillights and NOT doing the wiring on 20 and everything was ok I just had a bulb out on dash and no use of the rear fog

21 does the same thing as 20 when I switch to parking lights only the driver side DRL and rear fog come on

The Vortex thread didn't say anything about swapping the gray/white stripe with blue/green stripe wires in the first few pages. also I codded it from 20 to 04 and everything works now. Post 10 on this thread was a big help. Hope it helps the next person who stumbles across this.

http://www.golfmk6.com/forums/showthread.php?t=55943