Sauce118
Ready to race!
What is the average cost for a k04 port and polish? Does anyone have any accurate info about the gains from before and after port and polish? I am interested in overhauling my k04 as I bought it used and beat the sh*t out of it. It was in good condition when I bought it; no shaft play, not pitted or rusted or discolored at all (it actually looked very clean and well taken care of!). It is still running strong, but I'm guessing it could be better at this point. I figured if I'm going to take it out and overhaul the bearings etc., that I would think about sending in for p&p depending on the price and performance benefits.
Also anyone have a good experience with a certain shop that did theirs?
Also anyone have a good experience with a certain shop that did theirs?