Oil pan bolt torque question.

I am getting ready to replace my oil pan, however I cannot find any specific torque settings for the pan itself? Is there a sequence that should be done in order to allow for proper fitment and alignment? I appreciate any details that could help...
Btw I apologize if this has been addressed, just could not find these specs.

If the lower metal one its not too big of a deal. Snug and a bit more is how I would describe it. For pattern get a least 4 corners up and snug then criss cross when tightening.

Here is the workshop manual:
http://workshop-manuals.com/volkswagen/golf-mk6/power_unit/4-cylinder_injection_engine_(1.8_and_2.0_l_engine_chain_drive)/engine_lubrication/sump_and_oil_pump/removing_and_installing_lower_part_of_sump/

Thanks guys! Greatly appreciated...!