Plugging Intake Manifold Port

Installed a boost gauge and went with the no buzz tap kit originally. Found a good deal, so switching to the New South boost tap. Wondering what would be the most efficient way to plug the tapped hole?

I read someone mentioned a cap, but I'm not sure where I would obtain such a thing. Any other alternatives or insight would be greatly appreciated.

Did you drill into the blank fitting on the side of the intake manifold? If so I would just use a silicone cap from the hardware store and a small worm clamp or something

BudgetPhoenix said:

Did you drill into the blank fitting on the side of the intake manifold? If so I would just use a silicone cap from the hardware store and a small worm clamp or something

Click to expand...

Exactly, just tapped a small hole with the end of a screw. Cool, I'll give that a shot.