GOLFMK8
GOLFMK7
GOLFMK6
GOLFMKV

Neuspeed Power Module Install(Help)

JustinT

JustinT

Ready to race!
Hey guys, I got my Neuspeed Power Module today and I was wondering if anyone has any knowledge of putting it in. I tried to get the boost sensor off and it wouldn't budge and I'm sure the wastegate sensor would be the same. If anyone has any tips or could help, let me know. Thanks.
 
JustinT

JustinT

Ready to race!
snobrdrdan said:
This sounds odd, but it works easier if you push the harness forward into the connector while pulling up on the release tab (to break it loose), THEN pull it out (back) to release it from the plug

(same thing when doing the coil packs, for example)



Instructions btw:

http://www.neuspeed.com/media/attachments/388_64.10.13VAG.pdf
Click to expand...



Thank you sir! I'll try it again afterwork, is it possible to get to the wastegate sensor without lifting the car up?


Sent from my iPhone using Tapatalk
 
snobrdrdan

snobrdrdan

former GTI owner
I haven't installed one of these on this gen TSI, but it looks like that's a no since it's by the turbo discharge outlet
You'd have better access from under the car getting it plugged in
 
You must log in or register to reply here.
Top