GOLFMK8
GOLFMK7
GOLFMK6
GOLFMKV
VW GTI MKVI Forum / VW Golf R Forum / VW Golf MKVI Forum / VW GTI Forum - Golfmk6.com



Go Back   VW GTI MKVI Forum / VW Golf R Forum / VW Golf MKVI Forum / VW GTI Forum - Golfmk6.com > Search Forums


Showing results 1 to 25 of 335
Search took 0.03 seconds.
Search: Posts Made By: bebersol
Forum: Golf R 2.0T Engine / Drivetrain / Exhaust / Tunes 09-14-2018, 03:41 PM
Replies: 3
Views: 593
Posted By bebersol
it's a bad purge valve! 06E906517A maybe a...

it's a bad purge valve!
06E906517A

maybe a $15 item.
happens alot, most people go to dealer because of the CEL. Easy fix.
Forum: VW Golf R Forum 09-14-2018, 03:35 PM
Replies: 56
Views: 11,608
Posted By bebersol
I know, my 2013 is @ 46k and I thought I was low.

I know, my 2013 is @ 46k and I thought I was low.
Forum: VW Golf R Forum 09-14-2018, 03:32 PM
Replies: 6
Views: 707
Posted By bebersol
The Tyrol sport brake deadset will likely take...

The Tyrol sport brake deadset will likely take care of the brake clunk. Its not too hard to do, just buy a set of long nose C-clip pliers off Amazon to make it easier.
If your sub-frame has ever...
Forum: VW Golf R Forum 09-12-2018, 06:07 PM
Replies: 7
Views: 597
Posted By bebersol
I run a stock suspension with the tyrol sport...

I run a stock suspension with the tyrol sport deadset kit and a xbrace. I like this setup because it takes the flex and slop out of the chassis and allows the suspension for work as designed.
Forum: VW Golf R Forum 07-17-2018, 05:30 PM
Replies: 8
Views: 1,255
Posted By bebersol
You don't really need to put much torque on the...

You don't really need to put much torque on the HPFP fasteners. I use a torx driver in the end of a screwdriver handle until it's snug. You're fastening into aluminum, so it doesn't take a lot of...
Forum: VW Golf R Forum 07-13-2018, 05:41 PM
Replies: 6
Views: 515
Posted By bebersol
most people with modded HPFP do about every 10k,...

most people with modded HPFP do about every 10k, with the stock HPFP I change every 20 - 25K (miles). If it's unknown when it was last done I'd do it. its about $40 in parts and 15 minutes of labor....
Forum: VW Golf R Forum 07-13-2018, 05:36 PM
Replies: 6
Views: 707
Posted By bebersol
The heat shield behind the turbo sometimes...

The heat shield behind the turbo sometimes rattles, but you might check the entire exhaust to see if there is a close clearance somewhere.

The braking thunk is common on R's, mine did it in...
Forum: Wheels + Tires 07-03-2018, 04:37 PM
Replies: 0
Views: 326
Posted By bebersol
Talladega Rims FS

$400 + shipping (or pick up in the DFW area)
3 = excellent shape
1 = minor rim damage

text @ 817-797-7409
Forum: VW Golf R Forum 07-03-2018, 04:29 PM
Replies: 13
Views: 913
Posted By bebersol
maybe you can buy a used head European head unit....

maybe you can buy a used head European head unit. You'll also be able to get the SW radio stations. SWF2
Forum: Golf R 2.0T Engine / Drivetrain / Exhaust / Tunes 06-29-2018, 05:33 PM
Replies: 4
Views: 5,175
Posted By bebersol
Thank you, all really good additions to the DIY!

Thank you, all really good additions to the DIY!
Forum: VW Golf R Forum 06-29-2018, 05:23 PM
Replies: 3
Views: 1,122
Posted By bebersol
still waiting for the old clutch to start...

still waiting for the old clutch to start slipping a little more....
Forum: VW Golf R Forum 03-27-2018, 06:35 PM
Replies: 2
Views: 927
Posted By bebersol
sounds typical, time to get a better clutch

sounds typical, time to get a better clutch
Forum: VW Golf R Forum 03-27-2018, 06:33 PM
Replies: 10
Views: 1,053
Posted By bebersol
wait a few months!

wait a few months!
Forum: VW Golf R Forum 12-29-2017, 03:54 PM
Replies: 3
Views: 1,122
Posted By bebersol
upgraded DMF clutch

ordered this from Sachs Racing
Forum: VW Golf R Forum 12-29-2017, 03:50 PM
Replies: 1
Views: 604
Posted By bebersol
here's the pic

here's the pic
Forum: VW Golf R Forum 12-29-2017, 03:48 PM
Replies: 1
Views: 604
Posted By bebersol
odyssey AGM battery

about 8 lbs lighter than OE and smaller too.
Forum: Golf MKVI photos, spyshots, videos, media 12-29-2017, 03:44 PM
Replies: 4,547
Views: 1,829,533
Posted By bebersol
csg

here's my 2013
Forum: VW Golf R Forum 12-29-2017, 03:29 PM
Replies: 3
Views: 1,092
Posted By bebersol
cam follower

I'm posting a pic of 2 HPFP cam followers.
the one on the left changed out at 21,000 mi is the factory cam follower, run with Castrol 5-40 full synthetic purchased from the dealer. I changed the...
Forum: VW Golf R Forum 10-15-2017, 12:25 PM
Replies: 7
Views: 2,954
Posted By bebersol
thanks, good to know...

thanks, good to know...
Forum: VW Golf R Forum 06-13-2017, 11:12 AM
Replies: 46
Views: 9,107
Posted By bebersol
I like it....

I like it....
Forum: VW Golf R Forum 05-25-2017, 04:30 PM
Replies: 1
Views: 649
Posted By bebersol
not that I know of, but you may check with...

not that I know of, but you may check with Ross-tech
Forum: VW Golf R Forum 03-24-2017, 01:56 PM
Replies: 14
Views: 3,295
Posted By bebersol
boron nitride increases the heat sink capability...

boron nitride increases the heat sink capability of the intercooler?
Forum: VW Golf R Forum 03-24-2017, 01:52 PM
Replies: 46
Views: 7,952
Posted By bebersol
No note, just smack and run ! that sucks

No note, just smack and run ! that sucks
Forum: VW Golf R Forum 03-23-2017, 11:48 AM
Replies: 14
Views: 3,295
Posted By bebersol
Agree with the dude, Also,think about doing...

Agree with the dude,

Also,think about doing the clutch at the same time, stock is probably pretty worn at 68K if it's the original, and going stage 2 will probably finish it off.
Forum: VW Golf R Forum 03-23-2017, 11:42 AM
Replies: 3
Views: 969
Posted By bebersol
Thanks, I asked this question a years ago. ...

Thanks,

I asked this question a years ago.

I'm going to remove mine and install a rock screen. seems I get a lot of small dents in the AC heat exchange.
Showing results 1 to 25 of 335

 
Forum Jump

All times are GMT -4. The time now is 12:35 AM.


Powered by vBulletin® Version 3.7.2
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.