So I had a bad weekend...
Seems like oil starvation, looking like I spun a rod Saturday. Had the car towed home, dropped the oil pan found lots of little tiny bits of metal, engine glitter, fun lol.
So I'm now planning on pulling the motor and building it to some extent. Also will be using this time to do some maintenance, timing chain, rear main seal, and setting up a BT kit FINALLY. I'm keeping this hung forever so might as well make it properly quick.
Gunna be a long build, I'm planning on a year until it's on the road again.
So first things first, anyone know of any good write ups on pulling the engine? Recommendations on internals? (Probably just rods but depends on the condition of the motor, if it needs bored or not). Anyone know of any machine shops in the D.C., Maryland area that are decent?
Will start hunting for a used BT kit as well.
Sent from my iPhone using Tapatalk