toxicfusion
Banned
Hey there!
over the weekend I finally got around to installing the 034 catch can. looks great! however during the install used a 27mm wrench to tighten down the AN fittings. On the catch can side - i dented one a little bit, as wrench was too close to the edge of the fitting and being soft
i'm noticing rattling from engine bay now? is this because of the boost tap fitting? Does not feel as snug as my previous one.
I had the original 034 boost tap that when to OEM PCV breather and it worked without rattles.
Lastly -- any one have opinions or ways to drain this can without unbolting it? Seems overly complicated.
over the weekend I finally got around to installing the 034 catch can. looks great! however during the install used a 27mm wrench to tighten down the AN fittings. On the catch can side - i dented one a little bit, as wrench was too close to the edge of the fitting and being soft
i'm noticing rattling from engine bay now? is this because of the boost tap fitting? Does not feel as snug as my previous one.
I had the original 034 boost tap that when to OEM PCV breather and it worked without rattles.
Lastly -- any one have opinions or ways to drain this can without unbolting it? Seems overly complicated.