MKV Aaron1
Ready to race!
Just so those with V3s are comforted, at 25" FTG, it is well within the guidelines for lowering in the manual.
Front:
They give a measurement from the center of the strut pinch bolt to the lower spring seating surface of 205mm (8.07") minimum (lowest) and 235mm (9.25"" maximum (highest). They also give a center of axle bolt to fender measurement of 320mm (12.6").
Rear:
They give a measurement from the top of the collar, to the spring seating surface of 12mm (0.47") minimum (lowest) and 32mm (1.26") maximum (highest). Their center of axle bolt to fender measurement is 325mm (12.8").
My only question is the 2 sets of measurements. The range of drop and the axle bolt to fender. Obviously if you are some places in the range, you will not match the axle/fender measurement.
I will be calling KW on Tuesday to see what they say.
If you want to go really low, the KW line (and PSS10s too) are not for you.
Front:
They give a measurement from the center of the strut pinch bolt to the lower spring seating surface of 205mm (8.07") minimum (lowest) and 235mm (9.25"" maximum (highest). They also give a center of axle bolt to fender measurement of 320mm (12.6").
Rear:
They give a measurement from the top of the collar, to the spring seating surface of 12mm (0.47") minimum (lowest) and 32mm (1.26") maximum (highest). Their center of axle bolt to fender measurement is 325mm (12.8").
My only question is the 2 sets of measurements. The range of drop and the axle bolt to fender. Obviously if you are some places in the range, you will not match the axle/fender measurement.
I will be calling KW on Tuesday to see what they say.
If you want to go really low, the KW line (and PSS10s too) are not for you.