Gary_1.4_dsg
Ready to race!
To use alloys wheel nuts on steel wheels????? :mad0259:
6
Is It Safe???!!!
- Thread starter Gary_1.4_dsg
- Start date
xHeartcoreboyx
IceCream GTI
Depending on the seating really, i think oem steel and oem alloy use the seam seating pattern.
Gary_1.4_dsg
Ready to race!
Yeh they are the same i did check this when i installed them witch i thort would be ok..
Why im asking is my nuts and fooking tight and now i rounded off the locking wheel nut :sign0052:
Thats easy, just hammer on a 12 point socket thats slightly smaller than the lug bolt. Preferably use a craftsman socket so you can go exchange it afterwards. You will damage the socket a bit but it should take off all four and this only takes 5 extra seconds to get each locking lug out. Wheel locks dont do ish. If someone wants something they will take it.
Really? I havent taken my wheels off my new 2011 yet. I used this method to remove the wheels from my 2002 after this jerkoff at a service station stole mine after having them do an inspection. If its free spinng I gotta get those lugs off so I dont have any problem in the future. Thanks for the headsup.
Gary_1.4_dsg
Ready to race!
Yeah has a spiining lug 
welded the lug to the bolt and used grips to get them off
welded the lug to the bolt and used grips to get them off LittleJohny
Go Kart Champion
What's a free spinning lug? :iono: