Roadrunner_GTI
Drag Racing Champion
Wrapped up install of a few items ahead of the upcoming VIR trackday July 6th.
First was a Tyrolsport hatch brace, which I'd been eyeing for a while and finally picked one up. Install was pretty straightforward, and initial impressions seem positive, though I'll know more once I get the car on track.
Second was a set of 034 Street Density motor and trans mounts. My oem mounts had 90k miles and were due to be replaced. Decided on the 034 units because they seem to be a good compromise between performance and daily driver comfort. I also installed a Neuspeed dogbone insert at the same time. This setup is just about perfect for me, definitely tightens up the drivetrain without adding NVH.
Next up will be swapping to my G-loc R12/R8 track pads and test this stuff out. [emoji41]
First was a Tyrolsport hatch brace, which I'd been eyeing for a while and finally picked one up. Install was pretty straightforward, and initial impressions seem positive, though I'll know more once I get the car on track.
Second was a set of 034 Street Density motor and trans mounts. My oem mounts had 90k miles and were due to be replaced. Decided on the 034 units because they seem to be a good compromise between performance and daily driver comfort. I also installed a Neuspeed dogbone insert at the same time. This setup is just about perfect for me, definitely tightens up the drivetrain without adding NVH.
Next up will be swapping to my G-loc R12/R8 track pads and test this stuff out. [emoji41]
Last edited: