APR/AWE/Techs - Resistance of a properly functioning rear O2 sensor heating circuit?

[Cybe]

Snapped my rear O2 sensor in half on a bump.

Despite rear O2 delete in flash, I have a CEL for the rear circuit warming sensor.

So a little modification, then -- can somebody provide this figure? Is an inline resistor is a workable fix, or can just shunt it like a brakepad wear sensor?

Not entirely sure which wires, either. :wub: Plz?

Thanks guys.

 

[Chris@Revo USA]

No software disables the rear 02 sensor, it must remain fully installed and functional on any tune I am aware of so a broken wire needs to be repaired or the sensor replaced.

Simply repair with a good quality crimp connector that has heat shrink tubing. Do not solder 02 sensor wires as it will alter the resistance and throw off the readings.

I actually have to do this tonight on my mk4, apparently my GF forgot she was driving a car 2" off the ground not 2' (we have a TJ also) and ran over a huge stick in our driveway after a storm ripping the wires. Drive to work this morning was not fun!

 

[Cybe]

Thank you for the reply, Chris.

I'm afraid this one won't be quite so simple due to the nature of the damage.