T-taps
This is definitely inspiring. I wonder if anyone has done the same thing with the non-DynaAudio system.
Your set up looks so clean!! Very nice attention to detail! What gauge wire did you use for the power/ground/remote turn on? Was it included with the LC2i?
I guess I should have been more specific, what gauge wire was used for the LC2i?
I guess I should have been more specific, what gauge wire was used for the LC2i?
A ton of people have - I thought that was even discussed a couple of times in this thread, if memory serves. Mine is non-DynAudio.
Nah, not that I read. I'm curious on what actually is the difference between the stock and DynaAudio. I now there's and amp, and am assuming some DSP options. I wonder if the speakers are actually different or not (haven't searched yet... I'm sure the answers are out there somewhere).
Sorry, guess I didn't read your question well. I just used some spare wire as well, but mine wasn't even 18 ga. Probably 20 or 22 ga. twisted pair. The instructions call for a 1A fuse on the LC2i; with a a run that small even something as small as 22 ga. should be more than sufficient. Of course, smaller wires are more likely to short, so make sure you fuse it.
Do I get just a basic 1amp fuse holder and run it inline? I dont think Ive seen any pics of the LC2i fused...everyone just uses the power and ground leads directly to the LC2i...